Disney Infinity Fans

It's still a work in progress. I will be adding a back panel, which will be white. And also, will be adding Plexiglas door panels on the front. Figured I'd share what I have done so far. I even have room for Crystal Mickey when he comes out.

Very well done. I think it looks great without the Plexiglas. My only improvement would be to paint the back panel a different them for each shelf. Just my opinion.

You have one problem with it ... you have to build a 2nd one for 2.0!

Very nice! And if your figures get nice and cozy close, you MIGHT be able to fit some 2.0 figures in there! Also I think that promotional blue gradient background might look nice and pull the whole thing together.

That looks amazing!! Don't think I'd be able to talk the better half into letting me build one for the living room though haha
Might take her up on the offer of a Disney room though

Very nice...that case is HUGE!!

Do you have the dimensions for each side and shelf, and the degree of the angle for the cuts?

@hoodoo - Actually I like it too without the plexiglas doors. The only reason I was going to put them on was to help keep dust off the figures.

@CCRunner524 - I already started on a completely different design for 2.0. Just need to wait on the final count of figures so I can figure out how big it needs to be.

@candyle73 - I was going to make the back panel white so it would brighten it up and make the figures more visible. But now that you mentioned the blue, I think it would look great too. Going to have to experiment with it.

@tabaer - I have all my measurements and angles in my notebook. It took a couple hours to design it and make sure the angles and everything was perfect. It is actually laid out for ten figures per shelf, but I spread them out a little more. Looks cleaner and less cluttered that way.

The whole thing is only 42" wide x 48" high.

If only I had room to build something this big... great job btw!