Disney Infinity Fans

I would like to see a forum contest for forum members to design Disney Infinity Art Inserts for the PDP Base Protectors. We have a ton of talented designers on this board, and it would be great to see the ideas that people comeup with once we know the official dimensions for the Art Inserts for the PDP Base Protctors. Then after the contest is over, the top designs can be printed by other members to use with their base protectors.

.

i like this suggestion

I'm up for this. When I saw the base protector I just knew that we would have people on here that would love to make designs for people to use in their protectors.

We may not know the dimensions until it actually comes out but we can always have the competition first and then rescale the art to the right dimensions when we actually know. We already have a rough idea for the circle base dimensions due to a few people on here owning the Mike figure already.

the question is ... would people actually bothered? there was a very disappointing number of entries to the last fan art competition

I would involved if it wasn't limited to the PDP base. If I could make my own base protector from scratch then I would definitely enter.

I would enter for 200% certain! I wanted to make one anyway.

Though Sherrif makes a good point- but of a shame that the last contest didn't get more entries...

I would enter again (but I'll put in some effort this time!).

I'll enter.